3 Phase Setup Guide

This is a summary guide of the important steps to set, while configuring the Eniscope and admin.eniscope.com for a 3 phase system.

You will find a full installation guide at: https://help.bestsupportdesk.com/solution/articles/4000119067-first-eniscope-installation-2018-

For the Eniscope installation and setup.

And a detailed quick start guide on the Admin.eniscope.com settings at: https://help.bestsupportdesk.com/solution/folders/4000002565

Physical installation

If measuring a 3 phase on 1 Input to the Eniscope, then L1 should be connect to the CT1, L2 connected to CT2, while L3 should be connected to CT3 for the voltage reference.

Eniscope Hub settings

For the Eniscope Hub, you only need to set the Meter 'Phase Configuration' to 3 phase during setup.

Admin.eniscope.com

Add Equipment

Although only for reference, we recommend you fill in the advanced configuration box, by selecting 3 Phase.

Add Dataview

For the dataview in the 3 Phase setup, you need to select the 'System' option.

You now have all the important settings for a single phase.

Analytics

In Analytics, you can select the System option (summarised) or the 3 phase under 'phase type' on the options tab. Then continue to select the meters, parameters and time interval of interest.